Recent Posts

Oil Change on 4th gen. Toyota 4Runner V6

I purchased a 2008 Toyota 4Runner Limited (4th generation) with the 4.0L V6 engine, in June 2021, to replace my aging and failing 2005 Dodge Ram 1500. In the five years I owned the Ram 1500, I never towed anything. I did use the truck to carry some large and heavy loads but that is so rare for me now, that if you run the numbers it is cheaper to rent a truck from Home Depot for that purpose. So I went with a 4Runner with a V6 engine, since I have always wanted one and unlike a 5th generation Runner it had the multi-mode 4WD with locking and unlocking center differential. I also have never been off-roading and hope to go someday this year with the 4Runner.

I had driven it about 5000 miles in 8 months and it was time to do an oil change, since the oil change MAINT light was blinking on the dash. This post outlines how to do the oil change in a V6 4th generation 4Runner and it is very simple.

Debadging Emblem on Infiniti G35 Coupe

In an earlier post we plastidipped the front grille and emblem on the Infiniti G35 coupe. To apply plastidip on the rear emblem, I first decided to debadge the car trunk. This was done in case I did not want to put the plastidipped emblem back on the trunk. This post quickly describes how to debadge a car so you can plastidip the logos correctly.

Installing Brake Pads and Bleed Brakes

In a previous post, we had replaced the rotors and brake calipers in the Miata, and this one describes changing the brake pads and bleeding the brakes. You need to bleed the brakes if you change the calipers. You must buy DOT-3 brake fluid, 2-3 cans just in case, from your local parts store.

Details on the front brake pads change can also be found in an earlier post.

Installing New Rotors and Brake Calipers

In an earlier post, we had done a front brake pads change in the Miata, but while doing that change realized that one of the bolts slipped because the threading in the calipers was damaged. So we ended up doing a complete front and rear caliper replacement using remanufactured stock calipers from RockAuto. The good thing about these new calipers was that they were painted red which would look great on our car. In this post, we demonstrate how to go about removing and installing calipers. This work was done in August 2020, but we only found time a year later to write this post. I spent hours editing the photos.

This post outlines the installation of new rotors and brake calipers for both front and rear of the car, and it has a lot of pictures. You may find that installation of the front calipers may have been demonstrated on Youtube but it has not been done for rear calipers.

The next post outlines how to do the brake pads, and bleed the brakes.

Plastidip Front Grille & Emblem on Infiniti G35 Coupe

The silver front grille and emblem of the Infiniti G35 Coupe was looking worn out and ugly. So I removed it using a trim removal tool from Harbor Freight (blue tool in Figure 1) and purchased a $7 black Plastidip spray can (Figure 2) from Home Depot to paint it. The process of doing this is very simple and can be done in under 20 minutes for the first coat, and every other coat can be applied every 30-40 minutes.